Menus in the WBM
5.4 The Switch menu
SCALANCE X-200
128 Configuration Manual, 03/2015, C79000-G8976-C285-06
Cable tester
Cable fault diagnostics
You can run fault diagnostics for the cables at each individual electrical Ethernet port. This
makes it possible to localize short-circuits and cable breaks.
This function is not possible with IRT devices.
To be able to run the fault diagnostics, the Ethernet cable must be plugged into the X-200.
There must, however, been no physical connection (link) to another network component.
Figure 5-39 Switch Port Diagnostics
Select the port to which the cable you are testing is connected.
This button activates the error diagnostics.
Displays the pair of wires in the cable.
Pairs 4-5 and 7-8 are not used.
To Next Page
Loading...
