Siemens SCALANCE X-200

Menus in the WBM
5.1 The System menu
SCALANCE X-200
60 Configuration Manual, 03/2015, C79000-G8976-C285-06
5.1.8
Select/Set Button
Select/Set Button Configuration
On this page, you can configure the functions of the SET button.
Figure 5-8 Select/Set Button Configuration
Restore Factory Defaults
Here, you decide whether the device is reset to factory defaults when the SET button is
pressed.
Enable/Disable Redundancy Manager
Here, you decide whether the redundancy manager can be switched on and off by pressing
the SET button.
Set Fault Mask
Here, you decide whether the information of the "Fault Mask" is used when the SET button is
pressed.