Configuration using WBM and CLI
4.2 Command Line Interface
SCALANCE X-200
Configuration Manual, 03/2015, C79000-G8976-C285-06
43
Command Line Interface
Starting the CLI in a Windows console
Follow the steps outlined below to start the Command Line Interface in a Windows console:
1. Open a Windows console.
2. Enter the "telnet" command followed by the IP address of the IE switch, for example:
C:\>telnet 192.168.200.29
3. When you log in, enter your user name "admin" or "user".
4. Enter your password.
Figure 4-3 CLI via Telnet
Starting the CLI in Web Based Management
Click on the "Console" entry in the upper menu bar of WBM. This automatically opens a
Telnet connection in which you can log in. To do this, a standard program must be specified
for Telnet connections in your operating system or in your browser.
As an alternative, instead of entering full CLI commands, you can simply enter the first letters
and then press the Tab key. The Command Line Interface then displays a command starting
with the letters you typed in. If the command displayed is not the command you require,
press the Tab key again to display the next command.
To Next Page
Loading...
