Siemens SCALANCE X-200

Menus in the WBM
5.4 The Switch menu
SCALANCE X-200
138 Configuration Manual, 03/2015, C79000-G8976-C285-06
Syntax of the Command Line Interface
Table 5- 36 Switch LLDP - CLI\SWITCH\LLDP>
Command
Description
Comment
info
Displays the current LLDP settings.
lldpport [ports] <mode> Changes the LLDP settings for one or more ports.
The <mode> parameter can have the following val-
ues:
• RX - receive only
• TX - send only
• TX RX - send and receive
• D - disables sending and receiving.
Example:
The command "lldpport 1,2,3 rx" specifies that LLDP
frames are only received on ports 1-3.
Administrator only
Note
With X
-200IRT IE switches, only the following settings are possible:
•
Port sends and receives LLDP frames.
•
LLDP frames are sent but not received.
5.4.9
DCP
DCP Configuration
On this page, you can configure the handling of frames of the Discovery and basic
Configuration Protocol (DCP) per port.
The DCP protocol is used to detect nodes in a network and to assign basic parameters such
as the IP address, system name etc. to them.
To allow the logical structuring of networks, the sending of DCP frames can be enabled or
disabled port-oriented on an X-200 IE switch.
Note
The sending of DCP frames can be disabled in STEP 7 using the "End of
detection of
accessible nodes" function.