Menus in the WBM
5.3 The Agent menu
SCALANCE X-200
86 Configuration Manual, 03/2015, C79000-G8976-C285-06
SNMP Trap Config
Agent Trap Configuration - SNMP Traps for Alarm Events
If an alarm event occurs, the IE Switch X-200 can send traps (alarm frames) to up to two
different (network management) stations at the same time. Traps are sent only for events
specified in the Agent Event Configuration menu.
Figure 5-18 Agent Trap Configuration
Here, you enter the addresses of the stations to which the IE Switch X-200 will send traps.
Click on the check box next to the IP addresses to enable the sending of traps to the
corresponding stations.
To Next Page
Loading...
