Configuration using WBM and CLI
4.1 Web Based Management
SCALANCE X-200
Configuration Manual, 03/2015, C79000-G8976-C285-06
41
Simulation of the LEDs
Display of the operating state
IE Switches X-200 have several LEDs that provide information on the operating state of the
devices. Depending on its installation location, direct access to the X-200 is not always
possible. WBM therefore provides a simulated display of the LEDs.
Figure 4-2 Page section with simulation of the LEDs
At the top left of the WBM user interface, there is a schematic representation of the LEDs on
your X-200. The traffic display is not shown realistically; in other words the LEDs do not
flash.
On the device itself, the power supply and the redundant power supply are displayed by a
single LED. In the simulation there is a separate LED for each.
There is also one common LED on the device for the "Redundancy manager" and "Standby"
functions. In the WBM, these functions are simulated by two individual LEDs.
To Next Page
Loading...
