Siemens SCALANCE X-200

To Next Page

To Previous Page

Menus in the WBM

5.3 The Agent menu

SCALANCE X-200

84 Configuration Manual, 03/2015, C79000-G8976-C285-06

5.3.3

SNMP Config

Note

X-200IRT IE switches with firmware versions V4.0 and lower only the SNMPv1/v2 mode

is possible.

Agent SNMP Configuration - Configuration of SNMP for an IE Switch X-200

On the SNMP Agent Configuration page, you make basic settings for SNMP. For detailed

settings (traps, groups, users), there are separate menu commands in WBM.

Figure 5-17 Agent SNMP Configuration

SNMP enabled

Here, you can decide whether only SNMPv3 or also SNMPv1/v2 can be used.

SNMP Read Only

Enables/disables write protection for SNMP variables.

SNMP Community Strings

Read Community String

Displays the user name for read access to SNMP variables.

Write Community String

Displays the user name for write access to SNMP variables. Here, changes can only be

made, when write protection (SNMP read only) has been disabled.

Traps

Here, you can enable or disable the sending of SNMP traps.

Other manuals for Siemens SCALANCE X-200