Siemens SCALANCE X-200 Configuration Manual

Preface
SCALANCE X-200
Configuration Manual, 03/2015, C79000-G8976-C285-06
5
Content of the Configuration Manual
This manual describes the configuration of IE switches.
You will need to configure IE switches if you want to use functions such as SNMP, loop
detection, ring redundancy or e-mail. The manual also covers the question of firmware
updates and the C-PLUG.
Before configuration, the device must be installed and connected up. You will find a
description of the necessary steps for this in the Operating Instructions.
The following table shows you which information you will find in which chapter.
Topic
Chapter
You would like to know how an IP address is struc-
tured and which options you have for assigning an IP
address to an IE switch.
Assignment of an IP address (Page 33)
You would like to configure an IE switch and require
information on the relevant CLI commands or want to
know which pages of Web Based Management you
need to edit.
Configuration using WBM and CLI (Page 37)
You want to know how to manage an IE switch with
SNMP.
Configuration via SNMP (Page 153)
You would like information about the IRT technology
with SCALANCE X-200.
IRT communication with X-200 (Page 29)
You want to know how you can use the options of
PROFINET IO for a connected IE switch.
Connection to PROFINET IO (Page 155)
You want to update the firmware.
Downloading firmware (Page 171)

Siemens SCALANCE X-200 Specifications

General

Brand	Siemens
Model	SCALANCE X-200
Category	Switch
Language	English