Siemens SCALANCE X-200 - Page 82

Menus in the WBM
5.3 The Agent menu
SCALANCE X-200
82 Configuration Manual, 03/2015, C79000-G8976-C285-06
Default gateway
If the PC with the Internet browser is not in the same subnet as the IE Switch X-200, you
must enter the IP address of the default gateway here.
Syntax of the Command Line Interface
Table 5- 14 Agent Configuration - CLI\AGENT>
Command
Description
Comment
info
Displays information on the agent settings.
telnet [E | D] Enables/disables the TELNET function Administrator only
ssh [E | D]
Enables/disables the SSH function.
Administrator only
mail [E | D]
Enables/disables the mailing function.
Administrator only
dcp [RO | RW] DCP is activated in the mode
• RO = Read Only or
• RW = Read and Write
Administrator only
mgmntacl [E|D]
Enables / disables management ACL.
Administrator only
ping [-c number]
[-s length]
<IP address>
Sends a number of packets to the specified IP ad-
dress. If the parameters for number and length are
omitted, an IE switch sends ten packets each with a
length of 128 bytes.
Example:
ping -c 5 -s 256 192.168.1.1
Five packets with a length of 256 bytes are sent to
IP address 192.168.1.1.
-
Table 5- 15 Agent Configuration - CLI\AGENT\IP>
Command
Description
Comment
info
Displays information on the IP settings.
ip [IP address]
Specifies the IP address. DHCP is disabled.
Administrator only
subnet [subnet mask]
Specifies the subnet mask.
Administrator only
gateway [IP address]
Specifies the IP address of the default IP gateway.
Administrator only
dhcp [E | D]
Enables / disables DHCP.
Administrator only
dhcptype [M | N | C | D] Specifies the DHCP parameters:
- M MAC address
- N system name
- C client ID
- D PNIO device name
Administrator only
clientid [client ID]
Specifies the DHCP client ID.
Administrator only