9 Operation at Use of a PC
9.3 Configuration of the Device
246 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Parameterizing the Indications of a Modbus Slave Device
If you want to change the settings of the indications of a Modbus slave device (for example, Modbus slave de-
vice 1), proceed as follows:
✧ Click the button Indications..
Figure 9-72 Indications 1-6
✧ In the list boxes, select the parameters according to Table 8-26 and Table 8-27. Enter the desired values
in the fields.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
MAN_SICAM_Q100_US.book Page 246 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
