Communications configuring
3-56 System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
• The diagnostics data is dependent on the slave type.
• The first 16-byte slave diagnostic data are output.
• Additional slave diagnostic data can be output with SEL>1000.
Further information
on slave-specific diagnostics data, refer to the user documentation
"COM PROFIBUS" and the User Documentation for the individual
PROFIBUS slaves.
Slave type SPC slaves,
general
ET 200U ET 200B ET 200K SPM
slave
ET 200C
8DE/8DA
DP
stand.
slaves
Connection
D01 low Status 1 Diagnostics
high Status 2 according
to the
standard
D02 low Status 3 6 bytes
high Master PROFIBUS address
D03 low Identification number, high byte
high Identification number, low byte
D04 low Header, device-related diagnostics
high Device diagnostics U Device
diagnos. B
0 0 0
D05 low Header identification-
related diagnostics
0 0 0 0
high BG 7-0 0 Channel 7-0
D06 low BG 15-8 0 Channel 15-8 0 Device-
high BG 23-16 0 Channel 23-16 0 specific
D07 low BG 31-24 0 Channel 31-24 0 diagnostics
high Additional
device-
Irrelevant
D08 low specific Irrelevant
high diagnostics Irrelevant
Table 3-25 Overview of the structure of the diagnostics data for Siemens DP slaves
Diagnostics data of
SIEMENS DP
slaves
To Next Page
Loading...
Need help?
General
