Communications configuring
3-108 System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
Rules:
• The communications reference is as required within the framework of
the general rules.
• Local LSAP must be the same as the "Remote LSAP" of the remote
client.
• The remote address and remote LSAP can be entered, defined, but
then only the appropriately selected client can establish a connection
(access protection!); or both values can be set to 255, and then the
association is open for all.
• Max. PDU length should only be changed, if a remote client cannot
handle the specified length.
• The monitoring interval must coincide with the remote client.
• The Read, Write, Get OV(detailed version) utilities and symbolic
addressing are always supported from SIMADYN D servers as
responder (".ind"). The information report utility is not required.
• The maximum number of parallel "Receive" tasks must be set at least
as high as the maximum number of "Transmit" tasks of the partner.
Features:
• Non-cyclic data transfer
• SIMADYN D is exclusively a client.
• A connection (minimum) must be configured for each remote server.
• SIMADYN D establishes the connection and initiates data transfer.
• The objects, which SIMADYN D accesses in the remote server, are
defined by the CFC configuring (address stage 2 at the address I/O).
• Several utilities can run in parallel
Application:
• All SIMADYN D utilities, where SIMADYN D is a client.
Non-cyclic client
To Next Page
Loading...
Need help?
General
