Siemens Simantic ET200SP - Connecting PROFINET IO to the Cpu;Interface Module Via BA 2 Xscrj Busadapter

Wiring
5.12 Connecting interfaces for communication
Distributed I/O system
108 System Manual, 12/2016, A5E03576849-AG
5.12.3
Connecting PROFINET IO to the CPU/interface module via BA 2xSCRJ
BusAdapter
Introduction
You can connect PROFINET IO to the CPU/interface module optically with fiber-optic cables
using an SC RJ connector via the BA 2×SCRJ BusAdapter. To do this, screw the
BA 2×SCRJ BusAdapter onto the CPU/interface module and insert the SC RJ connector.
You can loop PROFINET through optically via the integrated 2-port switch.
Figure 5-18 BA 2×SCRJ BusAdapter
Required tools
3 to 3.5 mm screwdriver
Required accessories
● Connector for PROFINET connection: IE SC RJ POF plug
● Fiber-optic cable:
– IE POF standard cable (6XV1874-2A)
– IE POF trailing cable (6XV1874-2B)
– IE PCF standard cable (6XV1861-2A)
– IE PCF trailing cable (6XV1861-2C)
– IE PCF-GI (6XV1861-2D)