Siemens Simantic ET200SP User Manual

Installation
4.8 Mounting further accessories for motor starters
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
71
4.8.2
Mounting the mechanical bracket for the BaseUnit
Introduction
To achieve higher stability, you can use a mechanical bracket on 7.5 mm and 15 mm
mounting rails.
You must use the mechanical bracket in the following situations:
● When using a 15 mm mounting rail
● With a vertical mounting position
● For applications according to shipbuilding standards in all mounting positions with 7.5 mm
and 15 mm mounting rails
You can find further information on the mechanical bracket in chapter "Installation conditions
for motor starters (Page 58)".

Siemens Simantic ET200SP Specifications

General

System Type	Modular I/O System
Mounting	DIN Rail
Power Supply	24 V DC
Category	I/O Systems
Protection Class	IP20
Modularity	Yes
Communication Protocols	PROFINET, PROFIBUS
Digital Inputs	Available (varies by module)
Digital Outputs	Available (varies by module)
Analog Inputs	Available (varies by module)
Analog Outputs	Available (varies by module)
Number of Modules per Station	Up to 64
Module Width	15 mm, 20 mm, 22.5 mm (depending on module type)