Commissioning
10.2 Commissioning the ET 200SP for PROFINET IO
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
203
ET 200SP as an IO device
Configuration example
To use the ET 200SP distributed I/O system as an IO device, you need the IM 155-6 PNxx
interface module.
Figure 10-3 ET 200SP as an IO device
For commissioning of the ET 200SP distributed I/O system as an IO device on the
PROFINET IO, we recommend the following procedure:
Table 10- 3 Procedure for commissioning the ET 200SP as an IO device for PROFINET IO
Section Installation (Page 54)
2 Connecting ET 200SP
• Supply voltages
• PROFINET IO
• Sensors and actuators
Section Wiring (Page 75)
Configuring IO controller
Documentation of the IO controller
Switching on supply voltages for the IO controller
Documentation of the IO controller
6 Switching on supply voltages for IO devices Interface module
(http://support.automation.siemens
.com/WW/view/en/55683316/1333
Downloading the configuration to the IO controller
Switching IO controller to RUN mode
Documentation of the IO controller
To Next Page
Loading...
