Siemens Simantic ET200SP - Optional Markings

Wiring
5.15 Labeling ET 200SP
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
135
5.15.2
Optional markings
Introduction
In addition to the factory markings, there are also other options for labeling and/or marking
terminals, BaseUnits and I/O modules for the ET 200SP distributed I/O system.
Optional markings
● The color identification labels are module-specific labels for color coding the potentials of
the I/O modules. A color code (
C
olor
C
ode, e.g. CC01) is printed on each color
identification label and I/O module. The color code allows you to read which color
identification label is required for the terminals of the associated BaseUnit directly from
the I/O module. The following versions of color coded labels are available:
– Module-specific color combinations for the process terminals (see the device manuals
I/O modules
(http://support.automation.siemens.com/WW/view/en/55679691/133300)). The
different colors have the following meaning: Gray = input or output signal, red =
potential +, blue = ground.
– For the AUX terminals in the colors yellow-green, blue or red
– For the add-on terminals in the colors blue-red
● The reference identification labels (in accordance with EN 81346) can be inserted onto
each CPU/interface module, BusAdapter, BaseUnit and I/O module. This makes it
possible to create a fixed assignment between the reference identification label of the
BaseUnit and the I/O module.
With the standard plotter setting, the reference identification label is suitable for automatic
labeling with E-CAD systems.