Wiring
5.12 Connecting interfaces for communication
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
121
BA LC/FC BusAdapter mounted
PROFINET connecting cable
Figure 5-29 Connecting the BA LC/FC BusAdapter to the interface module
Connecting PROFINET IO (port P3) to the CPU
Introduction
You use the RJ-45 bus connector to connect PROFINET IO (port P3) directly to the CPU.
● Cable ties with standard width of 2.5 mm or 3.6 mm for strain relief
● Please observe the specifications in the PROFINET Installation Guide
(http://www.profibus.com).
Mounting the bus connector
Mount the PROFINET connector in accordance with the instructions in the PROFINET
Installation Guide (http://www.profibus.com).
To Next Page
Loading...
