Siemens Simantic ET200SP - 9.2 Creating the control data record

Configuration control (option handling)
9.2 Creating the control data record
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
177
9.2
Creating the control data record
9.2.1
Introduction
Required steps
To create a control data record for the configuration control, follow these steps:
1. Create a PLC data type which contains the structure of the control data record.
The following figure shows a PLC data type "CTR_REC", which contains the structure of
the control data record for an ET 200SP interface module.
Figure 9-3 Creating control data record 196 using an IM 155-6 PN HF as an example
2. Create a global data block.