Siemens Simantic ET200SP - Shipping and Storage Conditions; Mechanical and Climatic Environmental Conditions

Technical specifications
14.4 Shipping and storage conditions
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
279
14.4
Shipping and storage conditions
Introduction
The ET 200SP distributed I/O system exceeds requirements in terms of shipping and
storage conditions according to IEC 61131-2. The following information applies to modules
that are shipped and/or stored in their original packaging.
Table 14- 8 Shipping and storage conditions for modules
Type of condition
Permissible range
Free fall (in shipping package)
≤1 m
Temperature From -40 °C to +70 °C
Barometric pressure 1080 hPa to 660 hPa (corresponds with an altitude
of -1000 m to 3500 m)
Relative humidity 5% to 95%, without condensation
Sinusoidal oscillations according to
IEC 60068-2-6
5 - 8.4 Hz: 3.5 mm
8.4 - 500 Hz: 9.8 m/s
2
Impact acc. to IEC 60068-2-27
1)
250 m/s
2
, 6 ms, 1000 shocks
1) Not applicable to motor starters
14.5
Mechanical and climatic environmental conditions
Operating conditions
The ET 200SP distributed I/O system is suitable for use in weather-proof, fixed locations.
The operating conditions exceed requirements according to DIN IEC 60721-3-3:
● Class 3M3 (mechanical requirements)
● Class 3K3 (climatic requirements)
You will find the permissible ambient conditions for the motor starter in the Technical data of
the motor starter (https://support.industry.siemens.com/cs/ww/en/ps/21859/td).