Siemens Simantic ET200SP - Applying Reference Identification Labels

Wiring
5.15 Labeling ET 200SP
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
139
5.15.5
Applying reference identification labels
Procedure
Watch video sequence: "Labeling"
(http://support.automation.siemens.com/WW/view/en/95886218)
Proceed as follows to install a reference identification label:
1. Break off the reference identification labels from the sheet.
2. Insert the reference identification labels into the opening on the CPU/interface module,
BusAdapter, BaseUnit and I/O module. The opening is located on the top of the BaseUnit
or I/O module.
Note
Reference identification label
The printable side of the reference identification label must be facing
forward.
①
Reference identification labels
②
Opening for label
Figure 5-36 Applying reference identification labels