Siemens Simantic ET200SP - Page 129

Wiring
5.14 Mounting/disassembly of motor starters
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
129
Note
Parking position/OFF
This position is only permissible for maintenance purposes and not for continuous
operation. In this position, dust protection and mechanical durability are not ensured.
If you do not use the motor starter for an extended period, remove it and
attach the BU
cover (3RK1908
-1CA00-0BP0).
5. Mount the touch protection cover for the infeed bus on the last BaseUnit.
Note
Touch protection cover for the infeed bus
You will find out how to mount the touch protection cover of the infeed bus on a SIMA
TIC
ET
200SP motor starter in chapter "Mounting the cover for the 500 V AC infeed bus
(Page
69)".
6. To connect the assembly, mount the server module after the last BaseUnit.
Note
Server module
You can find out how to assemble/disassemble the server module in chapter "
Installing
the server module
(Page 68)".
Note
Removing the motor starter
You will find out how to remove the motor starter in chapter "
Replacing a motor starter
(Page
242)".