Technical specifications
14.1 Standards, approvals and safety notes
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
271
Factory Mutual Research (FM) according to
Approval Standard Class Number 3611, 3600, 3810 (ANSI/ISA 82.02.01)
CSA C22.2 No. 213
CSA C22.2 No. 1010-1
APPROVED for use in Class I, Division 2, Group A, B, C, D Tx;
Class I, Zone 2, Group IIC Tx
According to EN 60079-15 (Electrical apparatus for potentially explosive atmospheres; Type
of protection "n") and EN 60079-0 (Electrical apparatus for potentially explosive gas
atmospheres - Part 0: General Requirements)
According to IEC 60079-15 (Explosive atmospheres - Part 15: Equipment protection by type
of protection "n") and IEC 60079-0 (Explosive atmospheres - Part 0: Equipment - General
requirements)
Marking for Australia and New Zealand
The ET 200SP distributed I/O system meets the requirements of the standard
AS/NZS CISPR 16.
Korea Certificate KCC-REM-S49-ET200SP
Note that this device corresponds to limit class A in terms of the emission of radio frequency
interference. This device can be used in all areas, except residential areas.
이 기기는 업무용(A급) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시기
바라며 가정 외의 지역에서 사용하는 것을 목적으로 합니다.
To Next Page
Loading...
