Siemens SIMATIC ET 200SP User Manual

Wiring
3.1 Terminal and block diagram
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
22 Manual, 07/2018, A5E42674880-AA
Useable BaseUnits
You can use the following BaseUnits:
● Type BU type U0 dark-colored
● Type BU type U0 light-colored
A potential group opened with a light-colored BU type U0 must contain no dark-colored
BaseUnit of BU type A0 or A1.
Connection types
The AI Energy Meter HF supports the following connection types:
● 3P4W1, 3 phases, 4 conductors, balanced load
● 3P4W, 3 phases, 4 conductors
● 2P3W, 2 phases, 3 conductors
● 1P2W, 1 phase, 2 conductors
● 3 x 1P2W, 3 x 1 phase, 2 conductors
● 3P3W, 3 phases, 3 conductors
● 3P3W1, 3 phases, 3 conductors, balanced load
● 3P4WI, 3 phases, 4 conductors (only for current measurement)
The input circuit of the module must correspond to one of the listed connection types. Select
the appropriate connection type for the intended use.
You will find examples of connections in the section Connection examples (Page 23).
Information on the selection of a current transformer is available in the section Current
transformer selection data (Page 27).

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C