EasyManuals Logo

Siemens SIMATIC ET 200SP User Manual

Siemens SIMATIC ET 200SP
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
96 Manual, 07/2018, A5E42674880-AA
Parameters
13
13.1
Parameters
Parameters of the AI Energy Meter HF
You will usually configure the AI Energy Meter HF with STEP 7 (TIA Portal, if necessary with
HSP). In this case, STEP 7 (TIA Portal) checks the configured properties for plausibility
during configuration.
You can also assign parameters to the module using a GSD file and STEP 7 or the
configuration software of any provider. In this case, the module checks the validity of the
configured properties only after the configuration has been downloaded. Note that some
parameters depend on the selected connection type of the AI Energy Meter HF. For example
in the connection type 1P2W for measurements in single-phase AC network it does not
make sense to enter parameters for Phases 2 and 3. This is not checked by the system if the
GSD file is used.
The effective range of the parameters that can be set using a GSD file depends on the type
of bus system used:
Distributed operation on PROFINET IO in an ET 200SP system
Distributed operation with PROFIBUS DP in an ET 200SP system
In addition you can change the parameterized properties via the user program in RUN mode.
When you assign parameters in the user program, the "WRREC" instruction transfers the
parameters to the module using data records (see appendix Configuration via parameter
data records (Page 139)).

Table of Contents

Other manuals for Siemens SIMATIC ET 200SP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC ET 200SP and is the answer not in the manual?

Siemens SIMATIC ET 200SP Specifications

General IconGeneral
System TypeDistributed I/O System
MountingDIN Rail
Communication ProtocolPROFINET, PROFIBUS
IP RatingIP20
CategoryI/O Systems
Supply Voltage24 V DC
ModularityYes
Hot SwappingYes
Storage Temperature-40°C to +70°C
Digital InputsYes
Digital OutputsYes
Analog InputsYes
Analog OutputsYes
Communication InterfacePROFINET, PROFIBUS
Number of ModulesUp to 64
Relative Humidity5 to 95% (non-condensing)
Operating Temperature-25°C to +60°C

Related product manuals