Service and maintenance
11.9 Reinstalling the software
SIMATIC HMI IPC677C
158 Operating Instructions, 04/2013, A5E02722710-04
11.9.6 Installing drivers and software
Introduction
Note
In the case of multilingual operating systems (MUI versions), you have to set the regional
settings for menus and dialogs and the default language to English (US) before you install
new drivers or operating system updates.
Procedure
To install the drivers and software from the supplied "Documentation and Drivers" CD/DVD,
proceed as follows:
1. If your device has no CD/DVD drive, connect an external USB CD/DVD drive to a USB
port.
2. Insert the DVD.
3. Start the "START" program.
4. Select "Drivers & Updates" from the index.
5. Select the device and operating system.
6. Select the desired driver.
7. Open the folder with the driver data by clicking on the link next to "Driverpath".
8. Start the setup program in this folder.
Note
For a new installation of Windows operating systems, the chipset driver must be installed
before all other drivers, if required.
11.9.7 Installing the Intel RAID controller software
The software installation of the onboard RAID controller takes place with its driver
installation. Additional information on this is available in the section "Installation of drivers
and software".
11.9.8 Installing the optional burner or DVD software
Information about installation of the burner / DVD software is available on the supplied CD.
To Next Page
Loading...
Need help?
General
