Operation and configuration
8.2 Normal operation
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
79
8.2 Normal operation
8.2.1 Switching on the device
Requirement
● The peripheral devices are connected.
NOTICE
To comply with the EMC guideline of the device with I/O, ensure that the manufacturer
or supplier of the components used guarantees compliance with the regulations.
Connect the I/O devices via shielded cables with metal connectors. In doing so, the
shield must be connected over a wide area with the metal connector and the connector
must be firmly connected with the device housing.
● The operating system and the service packs have been installed and set up on the hard
disk of the device. Refer to the "Commissioning" chapter for more information.
● The pre-installed drivers and applications have been set up appropriately. Further
information is available in the "Operation and configuration" chapter in the section,
"Additional drivers and applications."
● The proper ambient and environmental conditions according to the specifications for the
device and the connected I/O modules have been observed.
To Next Page
Loading...
