Siemens SIMATIC HMI IPC677C - External Keyboards; Labelling Function Keys and Softkeys

Operation
9.2 Device with key panel
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
103
9.2.4 External keyboards
The keyboard layout has been set to "English/USA international." If you use a keyboard with
a layout other than the "English/USA international" layout, the key codes of the internal and
external keyboards might no longer correspond.
9.2.5 Labelling function keys and softkeys
Scope
This section applies only to control units with key panels.
Introduction
The control unit has two horizontal and two vertical keypads Assign user specific functions to
the keys as needed. Label the keys with labelling strips from the accessories.
Note
The device is supplied with a sheet of labeling strips.
CAUTION
Labeling
Label the function keys and softkeys to conform with the project. Labeling without reference
to a project leads to incorrect operations on the system to be observed.