Siemens SIMATIC HMI IPC677C - Exclusive PCI Hardware Interrupt

Detailed descriptions
16.3 System resources
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
219
             $&3,,54
     ,54
6ORW3&,

=< 3&,,173LQ$
= <3&,,173LQ%
= <3&,,173LQ&
=<3&,,173LQ'
6ORW3&,

=   <3&,,173LQ$
= <3&,,173LQ%
=<3&,,173LQ&
=< 3&,,173LQ'
6ORW3&,H[SUHVV

=< 3&,,173LQ$
<3&,,173LQ%
=< 3&,,173LQ&
<3&,,173LQ'
+RVW3&,,54/LQH
)XQFWLRQ
)

(

+

*

%

$

'

&

&RPPHQWV
,541XPEHU
1)
Host PCI-IRQ A to H will be assigned IRQ 16 to 23 permanently in ACPI mode. Host PCI-IRQ A to H will be
automatically assigned IRQ 0 to 15 in PIC mode. A specific assignment can not be enforced.
Y
Interrupt in APIC mode
Z
BIOS Default Interrupt in PIC mode (e.g. DOS)
Figure 16-4 Interrupt assignment of the slot connectors on the bus board
16.3.2.3 Exclusive PCI hardware interrupt
Applications demanding a high-performance interrupt require a high-speed hardware
interrupt reaction. The PCI hardware interrupt should be used only by one resource in order
to ensure high-speed reaction of the hardware.
Exclusive interrupt in APIC mode
IRQ assignments for Windows systems, (APIC mode)
Ethernet 1 16
1) 2)
Ethernet 2 17
1)
Profibus/MPI 19
1)
PCI slot 1 20
1)
PCI slot 2 21
1)
PCI Express slot 16
1) 3)
1)
Requirement: The modules in the PCI slots each require only one interrupt
2)
Requirement: VGA and PCI Express do not require an interrupt
3)
Requirement: VGA does not require an interrupt and Ethernet1 is disabled