Commissioning
7.9 Notes on operation
SIMATIC HMI IPC677C
74 Operating Instructions, 04/2013, A5E02722710-04
The "Rebuild to another disk" command initiates synchronization of the RAID1 system:
Figure 7-5 Restoring the RAID system
Note
The "SIMATIC PC DiagMonitor" diagnostics and alarm software also provides information
about the RAID status. This software only needs to be installed once - logons are not
required. The diagnostics and alarm software "SIMATIC DiagMonitor " is available as an
accessory.
To Next Page
Loading...
