Siemens SIMATIC IPC RW-543A - Page 99

BIOS description
11.3 Advanced menu
SIMATIC IPC RW-543A
Operating Instructions, 03/2023, A5E52332059-AA
99
SATA And RST Configuration
When you enter the BIOS Setup, the BIOS automatically detects the presence of SATA devices.
If no SATA device is installed to the corresponding SATA port, the SATA Port items show
Empty.
System
parameters
Function description Configuration
options
Default setting
M.2 NVMe
Enable or disable control the PCI ExpressRoot Port.
• [Enabled]
• [Disabled]
[Enabled]
SATA
Controller(s)
Enable or disable the SATA port SATA6G_1.
• [Enabled]
• [Disabled]
[Enabled]
SATA Mode
Selection
Determines how SATA controller(s) operate.
• [AHCI]
• [Intel RST With
Intel Optane
System
Acceleration]
[AHCI]
The following options show only when "SATA Mode Selection" = "[Intel RST With Intel Optane System Acceleration]".
• RST
SATA Interrupt Selection
• [MSIX]
• [MSI]
• [Legacy]
[MSIX]
SATA1∼4
Port
Enable or disable the SATA1 Port 1∼4.
• [Enabled]
• [Disabled]
[Enabled]
M.2 SATA
Port
Enable or disable the M.2 SATA Port.
• [Enabled]
• [Disabled]
[Enabled]
PCI Express Configuration
In the PCI Express Configuration page, you can configure the onboard devices.
System parameters Function description Configuration
options
Default setting
PCIE_16X_SLOT1
Enable or disable the PCIE_16X_SLOT1.
• [Enabled]
• [Disabled]
[Enabled]
PCIE_16X_SLOT1
Speed
Configure PEG 0:1:0 Max Speed.
• [Auto]
• [Gen1]
• [Gen2]
• [Gen3]
[Auto]
PCIE_16X_SLOT2
(MaxWidth 8x)
Enable or disable the PCIE_16X_SLOT2.
• [Enabled]
• [Disabled]
[Enabled]