Siemens SIMATIC MOBY D - Error Messages and Causes for MOBY D in Combination with the MDWAPI Library

Alarm, error and system messages
11.1 Error messages and causes for MOBY D in combination with the MDWAPI library
MOBY D
280 System Manual, 01/2010, J31069-D0147-A6-7618
11.1 Error messages and causes for MOBY D in combination with the
MDWAPI library
Table 11- 1 General errors
Error code
in HEX
Cause, remedy
0x00 OK:
 Data/parameters read or saved without errors
 Control command executed
Table 11- 2 Transponder status
Error code
in HEX
Cause, remedy
0x01 No transponder:
 No transponder within the detection field of the reader
 Transponder in detection field has been switched to silent
 Error in communication between reader and transponder. The reader can no longer
detect the transponder.
0x02 Invalid data:
 CRC16 checksum error in the received data
0x03 Write error:
Plausibility test of written data failed:
 Attempt to write to a read-only area
 Distance between transponder and read antenna too large
 Attempt to write during excessive ambient noise
0x04 Address error:
The requested data lie beyond the logical or physical address range of the transponder:
 The addresses lie outside the maximum address range of the transponder
 The addresses lie outside the configured address range of the transponder
0x05 Invalid transponder type:
This command is not supported by this transponder:
 Write or read attempt with a transponder
 A specific command is not supported by the transponder.
0x06 Read error:
Plausibility test of read data failed:
 Distance between transponder and read antenna too large
 Attempt to read during excessive ambient noise