Alarm, error and system messages
11.2 Error messages and causes for MOBY D with ASM and FC/FB 45 (direct MDS addressing)
MOBY D
282 System Manual, 01/2010, J31069-D0147-A6-7618
Table 11- 5 Error codes for ISO transponders
Error code
in HEX
Explanation of error codes in the transponder response
0x01 Command not supported (the request code was not recognized)
0x02 Command not recognized (e.g. due to a format error)
0x03 Option not supported
0x0F Unknown error
0x10 Specified block does not exist
0x11 Specified block is already disabled and cannot be disabled again
0x12 Specified block is disabled, its contents cannot be changed
0x13 Unsuccessful attempt to program the specified block
0x14 Unsuccessful attempt to disable the specified block
0xA0 -
0xDF
Error codes for user-specific commands
All others Reserved for future use
11.2 Error messages and causes for MOBY D with ASM and FC/FB 45
(direct MDS addressing)
11.2.1 General errors
Automation system switches to STOP
● OB 86 not programmed and a slave has failed.
● OB 122 not programmed and a slave has failed.
The error does not occur until FC/FB 45 is called.
● The pointer Params_DB, command_DB or DAT_DB does not exist or is pointing to a non-
existent address area.
To Next Page
Loading...
