Preface
Purpose of the operating instructions
The information in these operating instructions enables you to operate the ET 200PA SMART
Distributed I/O system with the IM 650 interface module, the ET 200PA SMART I/O modules,
and the single-width I/O modules of the S7-300 range released for PCS 7 as a DP slave.
Note
The ET 200PA SMART I/O modules function only in connection with an IM 650 interface
module. If the ET 200PA SMART modules are plugged behind an ET 200M interface module
(e.g., IM 153-2BA02) or behind an S7-300 CPU, the function of the ET 200PA SMART modules
is not available. The ET 200PA SMART modules indicate this with a red SF LED flashing at 2
Hz. An ET 200PA SMART module does not affect the ET 200M / S7-300 bus. This means that
other modules of the ET 200M / S7 300 station remain operable without restriction.
Basic knowledge required
To understand the operating instructions you require general experience in the field of
automation engineering.
Range of validity of these operating instructions
Module Article no. As of product ver‐
sion
Interface module Interface module IM 650-8PH 6ES7650‑8PH00‑xAA0 01
I/O modules Digital input module DI 16 x 24VDC 6ES7650-8DK70-xAA0 01
Digital input module DI 32 x 24VDC 6ES7650-8DK80-xAA0 01
Digital output module DO 16 x 24VDC/0.5A 6ES7650-8EK70-xAA0 01
Digital output module DO 32 x 24VDC/0.5A 6ES7650-8EK80-xAA0 01
Analog input module AI 8 x 13-bit 6ES7 650-8AE60-xAA0 01
Analog input module AI 8 x 16-bit 6ES7650-8AK60-xAA0 01
Analog input module AI 16 x 16-bit 6ES7650-8AK70-xAA0 01
Analog input module AI 8 x TC/4xRTD 6ES7650-8AR60-xAA0 01
Analog output module AO 8 x 12-bit 6ES7650-8BK60-xAA0 01
Active bus modules
(BM)
Bus module (BM) PS/IM 6ES7650 8PA00-xAA0 01
Bus module (BM) 2x40 6ES7650 8PC00-xAA0 01
Bus module (BM) IM/IM 6ES7650 8PB00-xAA0 01
x = 1: Module with conformal coating for use under elevated ambient conditions
x = 0: Standard module
ET 200PA SMART
Operating Instructions, 06/2019, A5E34192013-AB 3
To Next Page
Loading...
Need help?
General
