Siemens SIMATIC TeleControl DNP3 - SINAUT Special Diagnostics

Diagnostics
4.5 SINAUT special diagnostics
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
137
– TCP
– UDP
– SNMP
The following groups of the MIB II standard are not supported:
– Adress Translation (AT)
– EGP
– Transmission
●
Siemens Automation MIB
Write access is permitted only for the following MIB objects of the system group:
– sysContact
– sysLocation
– sysName
A set sysName is sent as the host name using DHCP option 12 to the DHCP server to
register with a DNS server.
For all other MIB objects / MIB object groups, only read access is possible for security
reasons.
The modules do not support traps.
For more detailed information about the MIB files and SNMP, refer to the manual /10/
(Page 189).
Configuration
For information on the configuration, refer to the section SNMP (Page 74).
4.5
SINAUT special diagnostics
4.5.1
SINAUT-Spezial-Diagnose - Gültigkeit
The SINAUT special diagnostics is available for the following modules:
● TIM 3V-IE DNP3
● TIM 4R-IE DNP3