EasyManuals Logo

Siemens SIMATIC TeleControl DNP3 User Manual

Siemens SIMATIC TeleControl DNP3
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Configuration
3.19 Telecontrol connections
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
89
Delete invalid or redundant connections
If there are unauthorized or unwanted redundant connections, you must delete a connection
path:
1. In the "Configured connection paths" table, select the unwanted connection path.
2. Click "Delete" in the shortcut menu.
3.19.3
Specifying connection paths
Rules for connection configuration
Note the following rules for connection configuration:
Connections can be configured for the following networks:
Connections in Ethernet networks between TIM modules and CPs
Connections in classic WAN networks (dedicated line/dialup network) - only between
TIM modules
You can create connections between endpoints (subscribers) that are configured in the
STEP 7 project.
Fields are available in the connection table for the address data and interface parameters
of both endpoints.
The endpoint of a connection is always the CPU, not the communications module.
Exception: Third-party device (see below)
A connection segment must be created for the way there and the way back for each
connection.
Example of a connection between Partner 1 and 2:
Connection segment 1 2
Connection segment 2 1
A connection must run over a single subnet.
You can create connections between an endpoint of the STEP 7 project and a "third-party
device" that is not configured in STEP 7. The third-party device is located in another
subnet and can be reached via a network gateway.
In this case, configure the network gateway as an endpoint of the connection.
You can configure single and redundant connections between two subscribers.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC TeleControl DNP3 and is the answer not in the manual?

Siemens SIMATIC TeleControl DNP3 Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC TeleControl DNP3
CategoryControl Unit
LanguageEnglish

Related product manuals