Configuration
3.4 Configuration of interfaces, networks and network nodes
Configuration - DNP3
36 Configuration Manual, 11/2018, C79000-G8976-C508-01
Basic data point settings of the TIM
Frame receipt
●
Check of the source address
If the option is activated, the address of the communications partner is checked in receive
frames. All data frames that do not originate from configured partners are discarded.
If the TIM is to receive and process data frames from several partners, the option must be
deactivated.
●
Number of data points in the normal cycle
Number of data points that were assigned to the normal read cycle.
Assignment in the data point configuration, see section "General" tab (Page 112).
●
Number of data points in the fast cycle
Number of data points that were assigned to the fast read cycle.
Assignment in the data point configuration, see section "General" tab (Page 112).
●
Maximum number of data points read from the CPU per sampling cycle.
Range of values: 0 ... 32000
Default: 1
With the setting 0 (zero), the function is disabled (no limitation).
For the read cycle, see section Read cycle (Page 115).
Configuration of interfaces, networks and network nodes
3.4.1
WAN settings of the interfaces
WAN settings
The following parameters determine the properties of the interfaces and the connected WAN
networks.
To Next Page
Loading...
Need help?
General
