Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
3
This manual is valid for all communications modules of the SIMATIC NET range listed below
which support the telecontrol protocol DNP3.
Note the structure of the documentation.
You can find the devices for which the configuration manual is valid in the section
Communications modules (Page 11).
Structure of the documentation
The documentation for the SIMATIC NET communications modules for Telecontrol consists
of the following manuals in each case:
● Manual or operating instructions
● One or more configuration manuals
The documentation for the modules specified above consists of the following manuals and
contents:
●
Manual / Operating instructions
Valid for the respective module or module group
– Application and functions
– Requirements (CPUs, configuration software, etc.)
– Hardware description
– Installation, wiring, commissioning, operation
– Diagnostics, maintenance
– Technical specifications, approvals, accessories
●
–
Volume 1 - System and hardware
Valid for: TIM 3V-IE, TIM 3V-IE Advanced, TIM 4R-IE
Hardware description, installation, wiring, commissioning, operation, technical
specifications, approvals
–
Volume 2 - Configuration under STEP 7 V5
Valid for: TIM 3V-IE, TIM 3V-IE Advanced, TIM 4R-IE
–
Volume 3 - Configuration under STEP 7 Professional (TIA Portal)
Valid for all ST7-capable communications modules
To Next Page
Loading...
Need help?
General
