Siemens SIMATIC TeleControl DNP3 - Page 4

Preface
Configuration - DNP3
4 Configuration Manual, 11/2018, C79000-G8976-C508-01
●
Configuration manual DNP3
Configuration and diagnostics in STEP 7 Professional (TIA Portal)
Valid for all SIMATIC NET communications modules that support the DNP3 protocol.
●
Configuration manual IEC
Configuration and diagnostics in STEP 7 Professional (TIA Portal)
Valid for all SIMATIC NET communications modules that support the protocol IEC
60870-5-101/104.
You can find the Internet links for the manuals in the Bibliography (Page 187).
Abbreviations/device names
This manual often uses the following abbreviations/acronyms:
●
Module / device
Names for the respective communications modules
●
WBM
"WBM" is the acronym for the "Web Based Management", the pages of the TIM Web
server for configuration and diagnostics data.
New in this release
First issue
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/21764/man)
Required experience
Knowledge in the following areas is required for configuration and diagnostics of the devices:
● Setting up industrial networks with security functions
● Data transfer via WAN networks
● SIMATIC STEP 7 Professional
Cross references
In this manual there are often cross references to other sections.
To be able to return to the initial page after jumping to a cross reference, some PDF readers
support the command <Alt>+<left arrow>.