Configuration
3.5 Ethernet interface
Configuration - DNP3
42 Configuration Manual, 11/2018, C79000-G8976-C508-01
You will find the specific parameters of the telecontrol protocol in the section DNP3
parameters of the interfaces (Page 53).
Web server access
3.5.3.1
CP
Access to the Web server of the CPU
The Web server is located in the CPU. Via the CP, you have access to the Web server of the
CPU.
From a PC you can access the Web server of the station if the PC is connected to the
system network via LAN.
You will find information on the Web server of the S7-1200 in the manual /7/ (Page 189).
You will find information on the Web server of the ET 200SP in the manual /8/ (Page 189).
TIM 1531 IRC
Access to the Web server
You can activate access to the Web server of the TIM via HTTP/HTTPS for each individual
Ethernet interface.
As default access is disabled. Refer to the explanations in section Web server (Page 59).
You enable the Web server and make further settings in the parameter group "Web server",
see section Security recommendations (Page 29). There you can also enable or disable
access.
For access to the Web server you need to enable access on the Ethernet interface ("Access
to the Web server") and enable the Web server itself "Web server".
To Next Page
Loading...
Need help?
General
