Siemens SIMATIC TeleControl DNP3 - Lan; Ethernet Interface [Xn]; C.8.1 Ethernet Interface [Xn]

WBM of the TIM 1531 IRC
C.8 LAN
Configuration - DNP3
178 Configuration Manual, 11/2018, C79000-G8976-C508-01
C.8
LAN
C.8.1
Ethernet interface [Xn]
● The three Ethernet interfaces of the TIM are selected via the upper tabs.
– X1 ... X3
● The parameters of the selected interface are shown in the lower series of tabs:
– IPv4 parameters
– IPv6 parameters
– Statistics
IPv4 parameters
Network attachment
●
MAC address
IP parameters
●
IP address
Current IP address
●
Subnet mask
Default or last configured subnet mask.
●
Default router
Configured default router
●
Address assignment
Shows how obtaining the IP address is configured in STEP 7:
– Set IP address in the project
– IP address from DHCP server
– Set IP address on the device
The IP address obtained using other services outside the configuration
Ports
●
Port number
Port of the interface
●
Connection status
– OK: Existing connection to the network
– Not OK: No connection