Siemens SIMATIC TeleControl DNP3 - Ethernet Interface

Configuration
3.5 Ethernet interface
Configuration - DNP3
40 Configuration Manual, 11/2018, C79000-G8976-C508-01
Figure 3-3 Network with master station (top), node station (center) and station (bottom)
3.5
Ethernet interface
3.5.1
Ethernet interface > address parameters
Ethernet interface > Ethernet addresses > IP protocol ...
In the following parameter groups configure the IP address parameters of the Ethernet
interface.
You will find information on configuration in the STEP 7 information system.
Ethernet interface > Port [Xn P1]
You will find information on configuration in the STEP 7 information system.
See also
Configuring WAN networks (Page 51)