Configuration
3.19 Telecontrol connections
Configuration - DNP3
88 Configuration Manual, 11/2018, C79000-G8976-C508-01
In the "Telecontrol connections" table, you can display or hide the columns, arrange them
and optimize the column width. Right-click on a column header to access the shortcut menu.
● Arrange columns
If you click on a column header and hold down the left mouse button, you can move the
column within the table.
● Show/Hide
You can show or hide individual columns using this function in the shortcut menu.
This increases the legibility of the table.
● Show all columns
Shows all columns of the table.
● Optimize width / Optimize width of all columns
You use these shortcut menus to optimize the width of the selected column or all columns
in the table.
The column width adapts to the widest entry in this column.
Some fields of the table can be edited, in others you configure the parameter via a drop-
down list.
Boxes with a missing or bad configuration are shown with a red background.
You can adapt the default names of the connections.
A maximum of 129 characters from the following ASCII character sets (numbers decimal)
are permitted:
●
Space , ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
●
No. 128, 130..140, 142, 145..156, 158..159, 161..172
€ ‚ ƒ „ … † ‡ ˆ ‰ Š ‹ Œ Ž ‘ ’ “ ” • – — ˜ ™ š › œ ž Ÿ ¡ ¢ £ ¤ ¥ ¦ § ¨ © ª « ¬
●
® ¯ ° ± ² ³ ´ µ ¸ ¹ º » ¼ ½ ¾ ¿ À Á Â Ã Ä Å Æ Ç È É Ê Ë Ì Í Î Ï Ð Ñ Ò Ó Ô Õ Ö × Ø Ù Ú Û
Ü Ý Þ ß à á â ã ä å æ ç è é ê ë ì í î ï ð ñ ò ó ô õ ö ÷ ø ù ú û ü ý þ ÿ
Faulty connection points, networks or parameters are highlighted in red in the tables.
Causes of faulty connections include, for example:
● Starting point and endpoint are identical.
● The connection runs through an impermissible network.
● The connection runs through an invalid subscriber.
To Next Page
Loading...
Need help?
General
