Siemens SIMATIC TeleControl DNP3 User Manual

WBM of the TIM 1531 IRC
C.9 Telecontrol
Configuration - DNP3
182 Configuration Manual, 11/2018, C79000-G8976-C508-01
–
80% limit reached
When the ST7 protocol is used, the TIM switches to the forced image mode at 80 %
occupation of the send buffer.
–
Overflow
100% occupation of the send buffer
Transmission path
Information on the transmission path
Local CPU
●
Interface ID
Ethernet interface of the TIM for connection with the local CPU
X1 (ETH1) / X2 (ETH2) / X3 (ETH3)
●
CPU type
Type of the local CPU
●
Connection status
– Connected
– Not connected
●
CFB reference
Local ID (decimal) of the S7 connection
●
Local TSAP
Local TSAP of the S7 connection
●
Remote TSAP
Remote TSAP of the S7 connection
●
IP address
IP address of the CPU
Remote partner
●
Address
IP address or WAN address of the interface of the TIM
●
Interface
Ethernet interface of the TIM for connection with the remote partner
X1 (ETH1) / X2 (ETH2) / X3 (ETH3)
●
CFB reference
Local ID (decimal) of the S7 connection

Siemens SIMATIC TeleControl DNP3 Specifications

General

Brand	Siemens
Model	SIMATIC TeleControl DNP3
Category	Control Unit
Language	English