Configuration in STEP 7
5.6 Configuring networks and network nodes in STEP 7 / NetPro
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
107
The Dialing Param. tab appears only with dial-up network nodes and includes all parameters
specific to call-numbers.
Image 5-20 Properties - DNP3 Dial-up Network TIM dialog, Dialing Param. tab
The parameters here are:
●
The modem specified in the hardware configuration is displayed.
●
Type of activation of the modem. Note that only the AT mode can be used on the internal
interface of the TIM.
Note
If two MD3 modems communicate with each other, they must not be operated in the 1200
baud, half
-duplex, AT mode.
To Next Page
Loading...
