Configuration in STEP 7
5.7 Configuring TIM modules
TIM DNP3
114 System Manual, 12/2015, C79000-G8976-C253-04
The parameters for a TIM module are divided among various tabs of the "Properties - TIM"
dialog. The following tabs are available:
● "General" tab
with general information and for modifying the module name or adding comments
● "Addresses" tab
with information on I/O address areas of the CPU
● "Time Service" tab
for setting the parameters for time-of-day synchronization of a TIM module
● "Interfaces" tab
for configuring the Ethernet and WAN interface(s)
● "Options" tab
with parameter assignment options for the message memory
-specific parameters are entered in the "Properties" dialogs for network
and network node parameter assignment. These are explained in the relevant sections.
To Next Page
Loading...
