Siemens SIMATIC TIM 3V-IE DNP3 - Standard Connecting Cable for the DNP3-Tims

Accessories
A.3 Connecting cables
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
321
A.3.1
Standard connecting cable for the DNP3-TIMs
A modem or other transmission device can be connected to the 9-pin connector of the serial
interface of the TIM. The following standard connecting cables are available for connection
to these connectors.
Connecting cables for the DNP3-TIMs
Connecting cables for the serial interface of the TIM
Order no.
Description
Illustration
6NH77701-4AL Connecting cable for connecting the serial interface of a
DNP3 TIM to one of the SINAUT modems MD2 or MD3
(RS-232).
Also suitable for linking the modems to a SIMATIC point-to-
point CP such as the CP 340, CP 341 or CP 441 with RS-
232 interface.
Cable length 1.5 m
6NH7701-5AN Cable for connecting the TIM (RS-232) to third-party mo-
dems or wireless devices with standard RS-232.
Cable length 2.5 m
6NH7701-4BN Cable with one end without connector for connecting the
TIM (RS-232) to a third-party modem or wireless device
(RS-232)
Cable length 2.5 m
6NH7701-0AR Test cable.
Cable for connecting two TIM modules via their RS-232
interface without modems (null modem).
Cable length 6 m