Siemens SIMATIC TIM 3V-IE DNP3 - Cpus for a Standalone TIM 4 R-IE DNP3 with S7-400 or S7-400 H

Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
35
1.12.2.3
CPUs for a standalone TIM 4R-IE DNP3 with S7-400 or S7-400H
Compatible CPU types for a standalone TIM 4R-IE DNP3
In standalone mode, in other words, without an S7-300-CPU, the TIM 4R-IE DNP3 is ideally
suited as a communications processor for an S7-400 or S7-400H. They are then linked over
one of the Ethernet ports of the TIM.
With an S7-400 or S7-400H, an Ethernet CP is used as the interface. The following S7-400-
CPUs can be linked over an Ethernet CP:
S7-400
CPU 412-1
ab 6ES7 412-1XJ05-0AB0
(Version 02)
CPU 412-2
ab 6ES7 412-2XJ05-0AB0
(Version 01)
CPU 412-2 PN/DP
ab 6ES7 412-2EK06-0AB0
(Version 01)
CPU 414-2
ab 6ES7 414-2XK05-0AB0
(Version 01)
CPU 414-3
ab 6ES7 414-3XM05-0AB0
(Version 01)
CPU 414-3 PN/DP
ab 6ES7 414-3EM06-0AB0
(Version 01)
CPU 414F-3 PN/DP
ab 6ES7 414-3FM06-0AB0
(Version 01)
CPU 416-2
ab 6ES7 416-2XN05-0AB0
(Version 01)
CPU 416-3
ab 6ES7 416-3XR05-0AB0
(Version 01)
CPU 416-3 PN/DP
ab 6ES7 416-3ES06-0AB0
(Version 01)
CPU 416F-2
ab 6ES7 416-2FN05-0AB0
(Version 01)
CPU 416F-3 PN/DP
ab 6ES7 416-3FS06-0AB0
(Version 01)
CPU 417-4
ab 6ES7 417-4XT05-0AB0
(Version 01)
S7-400H
CPU 410-5H
6ES7 412-5HX08-0AB0
(Version 01)
CPU 412-3H
6ES7 412-3HJ14-0AB0
(Version 01)
CPU 412-5H
6ES7 412-5HK06-0AB0
(Version 01)
CPU 414
-4H
6ES7 414
-4HM14-0AB0
(Version 01)
CPU 417-4H
6ES7 417-4HT14-0AB0
(Version 01)