Siemens SIMATIC TIM 3V-IE DNP3 - Data Objects: Partner and Send Parameters

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
194 System Manual, 12/2015, C79000-G8976-C253-04
6.6.11
Data objects: Partner and send parameters
Configuration of the objects and channels
You configure the data objects and their channels in two steps:
1. Configuring the objects
Here, you specify the properties valid for the entire object and all its channels.
– The communication partner
– Start index of the object
– Object number
– Send parameters
2. Configuring the channels
Here, you specify the properties of the individual channels of an object:
– Memory area of the CPU
– Send trigger for send channels
– Specific properties of the individual object types
Configuration of the objects (partner, start index, object number, send parameters)
Follow the steps outlined below:
1. Select a TIM with TD7onTIM in the directory tree.
2. Select the required data object in the list box at the top right.
The parameter assignment dialog below now shows the parameters of this object.
3. You set the parameters in this dialog.