Configuration in STEP 7
5.6 Configuring networks and network nodes in STEP 7 / NetPro
TIM DNP3
112 System Manual, 12/2015, C79000-G8976-C253-04
Image 5-23 Properties - Ethernet interface dialog, Parameters tab
The Parameters tab provides the following parameters:
● Set MAC address / use ISO protocol:
Since an Ethernet TIM does not use the ISO protocol but TCP/IP, this option remains
disabled.
● The IP address:
This has a default entry and cannot be changed here.
● The Subnet mask:
This has the default value 255.255.255.0 and can be changed / restricted.
To Next Page
Loading...
