Siemens SIMATIC TIM 3V-IE DNP3 User Manual

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
218 System Manual, 12/2015, C79000-G8976-C253-04
Parameters of CmdReceive:
Name:
Output mode
Range of va
l-
ues:
•
Pulse on
•
Latch on/off
Default:
Pulse on
Explanation:
Specifies the type of command The control code received from the master is
evaluated.
Name:
Max. pulse duration
Range of va
l-
ues:
0 ... 2147483647
Default:
0
Explanation:
Monitors the pulse duration sent by the master (On
-time). If the pulse dura-
tion received from the master exceeds the value configured here, the co
m-
mand is rejected.
If you enter 0 (zero), the monitoring is disabled.
Name:
Pulse duration equivalent time
Range of va
l-
ues:
0 ... 2147483647
Default:
0
Explanation:
Replacement value for the pulse duration If the pulse duration received from
the master exceeds the value configured in
“Max pulse duration“. The pa-
rameter is only used when “Max. pulse duration“ is configured.
If the value is 0 (zero), no replacement value is used.
Name:
Number of pulses
Range of va
l-
ues:
0 ... 255
Default:
0
Explanation:
Monitors the number of
pulses sent by the master (Count). If the number of
pulses received from the master exceeds the value configured here, the
command is rejected.
If you enter 0 (zero), the monitoring is disabled.
Channel "CmdFeedBack"
Channel type: DNP command response
Returns the value of the output address of the receiving channel “CmdReceive“ to the
master.

Siemens SIMATIC TIM 3V-IE DNP3 Specifications

General

Brand	Siemens
Model	SIMATIC TIM 3V-IE DNP3
Category	Control Unit
Language	English